It sounds like it could be the title of an Irish folk ballad... "Shimmin O The Chines." As many ballads go, the actual work has so far been a mixture of hope and tragedy.
Well, perhaps "tragedy" might be a bit of an overstatement. But, what was that I said in the last post? "Two steps forward, one step back?"
Well, perhaps "tragedy" might be a bit of an overstatement. But, what was that I said in the last post? "Two steps forward, one step back?"
In any case, Id made the shims by cutting a 14-inch piece of mahogany in half with a hand saw. Then I planed each half down to approximately 3/16" with a planer/jointer. I epoxied these into position along the low point in the port chine.
When I was planing down the overhanging edge, however, I wasnt paying enough attention to the angle at which I was holding my larger hand plane. Before I knew it, Id inadvertently gouged the side planking. Theres not much I can do about that now, other than fill the gouge in with epoxy. I guess its a good thing I wasnt planning on a bright finish for the sides.
When I was planing down the overhanging edge, however, I wasnt paying enough attention to the angle at which I was holding my larger hand plane. Before I knew it, Id inadvertently gouged the side planking. Theres not much I can do about that now, other than fill the gouge in with epoxy. I guess its a good thing I wasnt planning on a bright finish for the sides.
Mahogany shims for filling in that low spot along the port chine. |
The overhanging edge faired away quickly, but youve gotta watch the angle on those larger hand planes. |
A close-up of the gouge in the plywood. |
0 komentar:
Posting Komentar