Bottom panels complete

| |
Here are the two bottom panels taped and cut to shape.  I feel as if I am in the groove now and can get the side panels out a little quicker now. 
 
I did experiment with a number of release films for the fiberglass epoxy tape joints.
1.  6 mm plastic - was hard to get flat and fair.  wrinkles developed easily
2.  packing tape - harder to apply, but left a relatively smooth controllable surface.
3.  wax paper - best looking joint, but waxy residue must be cleaned.  I was warned by a more experienced builder that the wax could separate out of the paper, leaving a ghastly mess to clean up.  I did experience a little of this in the top joint, when I tried to remove the paper prior to full cure.  
Bottom line - will stick with the 6 mm plastic.  a little extra filling and sanding is part of the project.   

Related Posts by Categories

0 komentar:

Posting Komentar