After a couple of hours, I was finally able to get these two forms to horn in accurately at each corner. The problem was that the bottom panel was 1/4" too far aft. I used a block of wood and a mallet to persuade it forwards, then reattached the forms til even. Today, I will finish the forward frame and get the whole thing level prior to installing the transom. Hope to be able to begin locking the boat together this week.
slowly bringing into shape
Diposting oleh shintha | | 05.57Label: 3d, boat making, bringing, day, into, shape, slowly
After a couple of hours, I was finally able to get these two forms to horn in accurately at each corner. The problem was that the bottom panel was 1/4" too far aft. I used a block of wood and a mallet to persuade it forwards, then reattached the forms til even. Today, I will finish the forward frame and get the whole thing level prior to installing the transom. Hope to be able to begin locking the boat together this week.
Langganan:
Posting Komentar (Atom)
0 komentar:
Posting Komentar